The brake disc is one of the main safety elements of a car. In the article, we will discuss the principle of operation of disc brakes, the main signs of wear and clear criteria for when replacement is required.
Before you start reading this material, the Auto30 team strongly recommends paying close attention to the condition of the brake system, its components and units. Your life and health depend directly on it. Treat the content of the article with all seriousness.
The brake disc is one of the key elements of car safety. Despite the durable materials from which it is made, this part is subject to wear and damage due to constant loads and difficult operating conditions.
Disc brakes appeared in the middle of the 20th century and quickly became the standard for most passenger cars. Today, about 90% of new cars are equipped with them – due to their efficiency, simplicity of design, and affordable cost.
However, such a system has a disadvantage: a small contact area of the pad with the disc requires increased pressure in the brake system, which accelerates the wear of both parts.
Exact numbers vary depending on the manufacturer of the car and the discs themselves. Average mileage values are just a guideline, and actual wear depends on many factors.
Many car owners ask where to find information about acceptable thickness. The answer is simple: it is indicated on the disc itself. Manufacturers apply two numbers on the edge – the initial and the minimum allowable thickness. If the disc is worn down to the second mark, further operation is unsafe.
But in addition to natural wear, the condition of the discs is affected by the driving style, especially aggressive driving in urban conditions.
The main sign is a change in the car's behavior during braking. If steering wheel beating is felt during a sharp stop, it is time to check the discs. For an accurate diagnosis, it is better to remove the wheel and inspect the part.
Measurements are taken with a caliper in several places – wear may be uneven. It is also important to check the surface for deep scratches, burrs, and other damages. If defects are found, it is time to think about repair or replacement.
There are few options:
Some drivers try to economize and resort to dangerous methods, such as installing additional pads to compensate for disc wear. This can lead to brake locking while driving and loss of control.
Delaying the replacement of worn discs threatens not only with reduced braking efficiency but also with damage to other elements: cylinder pistons, CV joints, ball joints. Ultimately, "savings" will result in more serious expenses.
The brake disc is a consumable item subject to intensive wear and various damages. During sharp braking, its temperature can reach 400°C, and if water gets on the red-hot surface at this moment, the consequences can be critical. Cracks are just one possible problem, but deformation of the disc, which manifests as vibration during braking, is more dangerous. Over time, microcracks grow into deep grooves, worsening the performance of the brake system.
Another factor in accelerated wear is the ingress of sand and dirt between the disc and pads. This leads to groove formation, reduction of contact area, and consequently, reduced braking force. In addition, worn pads contribute to uneven disc wear.
Characteristic signs of wear:
The service life of brake discs directly depends on the driving style. Fans of sharp starts and emergency braking should be prepared for accelerated wear of both the pads and the discs themselves.
Monitor the condition of brake discs – your safety depends on it. Happy diagnostics and timely repairs!